Back on the road
Nice new steel flywheel - courtesy of Shacktune. 4kg and built in ring gear.
Held on by 4 ARP bolts and 4 Grade 8 capheads.
Finally got hold of the ceramic puck clutch plate - alignment tool was a 3/8 extension with race tape wrapped around to mimic the input shaft spline
It worked
Gearbox on place - no photos of us heaving and swearing
Back on the ground and cam run in at 2000rpm for 15minutes
Test run revealed the need for more top-end fuel so 0.05" added to the full load setting - currently 0.072" - final tweak will be done on a rolling road check this week
posted by andy t at 8:39 AM
1 Comments:
hi Andy if you read this could you give me an email on ,..wwess@bigpond.com..i have not been able to find your email info...regards
Post a Comment
<< Home